Provided Mode; Control; Data; Table 2. Data Selection Modes (Pld Version Ab-X) - Cirrus Logic CS492 Series Manual

The two major PLD modes for the CDB4923/300
are the PROVIDED resource mode and the EX-
TERNAL interface mode. When a PROVIDED
mode is chosen all clocks are provided by the dem-
onstration board, all audio data passes through the
PLD, and the DSP is controlled by the PC parallel
port interface. The EXTERNAL interface modes
allow the user to drive the audio data and control
pins of the DSP directly by wire-wrapping to stake
headers J11 and J12, bypassing the control PLD. It
should be noted that there are two variants of the
EXTERNAL interface mode. One EXTERNAL
mode provides direct access to all control and audio
data input pins of the CS492x/CS493xx, and the
second EXTERNAL mode allows the user to drive
the control signals of the CS492x/CS493xx while
audio data still comes from the CDB4923/300.
The DIP switch S3 is used to choose the different
routing schemes, and can be found in the Control
schematic of Figure 7. Table 2 provides a general
overview of the available PLD modes.
PLD Mode DATA_SEL2
0 LO
1 LO
2 LO
3 LO
4 HI
5 HI
6 HI
7 HI
NOTE: Because each mode of the Data Selection switch (S3) sets up a different hardware configuration, clock
and data lines may be momentarily directed to many different destinations during mode changes. Without
the proper initialization process after a reconfiguration, strange behavior may be observed. The recom-
mended procedure for performing changes to the routing configuration is to first generate a board reset
using the BOARD RESET switch (SW1). The CS492x/CS493xx will then require a soft reset
("CDB30RST.EXE -s" which performs a hardware reset and then sends the soft reset message
0x000001) and the proper hardware and application configuration messages for the new mode. A thor-
ough description of soft reset, hardware configuration, and application configuration can be found in the
software Application Notes AN115, AN120-123, AN140 or AN161-163.
10
DATA_SEL1 DATA_SEL0
LO LO
LO HI
HI LO
HI HI
LO LO
LO HI
HI LO
HI HI

Table 2. Data Selection Modes (PLD version AB-X)

CDB4923 CDB49300
5.1

Provided Mode

When the user has chosen a PROVIDED resource
mode, the PLD Mode determines the source of au-
dio data for the two data pins of the DSP (CMP-
DAT—pin 27 and SDATAN1—pin 22) and the
source of the system's oversampling clock
(MCLK). Table 3 lists the routing configurations
for each of the PROVIDED data selection modes.
5.1.1

Control

As mentioned earlier, when a PROVIDED mode
has been selected, all control of the CDB4923/300
is accomplished using the parallel port (J29). A
floppy disk is included with the CDB4923/300
which contains the control software described in
Appendix F: Board Control Software.
5.1.2

Data

All of the Data Selection Modes shown in Table 3
imply PC control. In Table 4, a brief description is
given for each data source listed in Table 3.
The general data flow of the system is illustrated in
Figure 2. A data path is shown for each of the
modes listed in Table 3.
AUDIO DATA, CONTROL,
and CLOCKS
EXTERNAL
EXTERNAL CONTROL
ONLY
PROVIDED
PROVIDED
PROVIDED
PROVIDED
RESERVED
RESERVED
CONTROL SOURCE
J11
J11
PC
PC
PC
PC
DS262DB2