Supplementary system components
7.7 Terminal module TM41
Table 7-33
Interface
Digital inputs
Bidirectional inputs/outputs
Relay outputs with changeover contact
Analog inputs
Analog outputs
Temperature sensor input (KTY84-130 or PTC)
NOTICE
Overheating if ventilation clearances are too small
Insufficient ventilation clearances result in overheating and therefore in more failures and a
shortened life of the component.
Maintain 50 mm ventilation clearances above and below the component.
Additional references
You will find detailed information about the TM31 in the
●
●
7.7
Terminal module TM41
Characteristics of the TM41
With the TM41 Terminal Module, the number of available digital inputs/digital outputs and the
number of analog inputs within a drive system can be expanded. In addition, the TTL output
can be used for encoder emulation. The TM41 is connected via DRIVE-CLiQ.
The TM41 contains the following terminals:
Table 7-34
Type
Digital inputs
Digital inputs/outputs
Analog inputs
TTL encoder output
114
Interface overview
SINAMICS S120 Control Units and Additional System Components Manual
SIMOTION D4x5 Commissioning and Hardware Installation Manual
Interface overview
Quantity
8
4
2
2
2
1
Quantity
4
4
1
1
SIMOTION D4x5
Manual, 04/2014