Siemens SIMOTION D4x5 Series Manual page 53

Interface characteristics
Table 4-5
Characteristic
Connector type
Cable type
Maximum cable length
Autocrossing
Dust protection filler plugs for
sealing unused Ethernet ports
Other
1)
Pin assignment
Table 4-6
Pin
1
2
3
4
5
6
7
8
Note
The MAC addresses are imprinted on an adhesive label that is located behind the protective
cover and can be seen from the front.
When connecting a PG/PC via Ethernet, the following points must be observed:
● If your PG/PC has an autocrossing function, crossed and uncrossed Ethernet cables can
● If your PG/PC does not have autocrossing, a crossed Ethernet cable must be used.
● If a hub or switch is located in between, an uncrossed Ethernet cable must be used
SIMOTION D4x5
Manual, 04/2014
X120 and X130
Devices with Ethernet interfaces can have various pin assignments. In the case of terminal devices,
for example, the send line may be on pins 1 and 2, while pins 1 and 2 on a switch or hub may connect
to the receive line. If two devices are connected using Ethernet, the type of device will dictate whether
a crossed or uncrossed Ethernet cable needs to be used. (For example, a crossed cable is required
if two Ethernet terminal devices are directly connected.)
Ethernet interfaces (X120 and X130)
Signal name
TXP
TXN
RXP
---
---
RXN
---
---
be used.
(assuming the hub/switch does not have autocrossing).
Type
RJ45 socket connector
Industrial Ethernet cable
100 m
no
5 filler plugs contained in the D4x5 scope of delivery
Filler plugs (50 pcs) order number: 6SL3066‑4CA00‑0AA0
The X120 and X130 interfaces are full-duplex 10/100-Mbit Ethernet
ports.
Both ports are wired as Ethernet terminals.
Signal type Meaning
Output Ethernet transmit differential signal
Output Ethernet transmit differential signal
Input Ethernet receive differential signal
--- Reserved, do not use
--- Reserved, do not use
Input Ethernet receive differential signal
--- Reserved, do not use
--- Reserved, do not use
Interfaces
4.3 Ethernet interfaces
1)
53