Siemens SIMOTION D4x5 Series Manual page 67

Ambient conditions
Table 5-4
Parameter
Permissible ambient temperature
● Storage and transport
● Operation
Permissible relative humidity
(without condensation)
Installation altitude
Organic/biological influences
● Storage
● Transport
● Operation
Pollution degree
Degree of protection according to EN 60529
(IEC 60529)
Atmospheric pressure
1)
Note
The components must be protected against conductive contamination, e.g. by installing them
in a control cabinet with degree of protection IP54 according to IEC 60529 or NEMA 12.
If conductive contamination can be excluded at the installation site, a lower degree of cabinet
protection may be permitted.
See Residual risks of power drive systems (Page 16).
Shipping backup batteries
Backup batteries may only be shipped in the original packaging. No special authorization is
required to ship backup batteries. The lithium content is approximately 300 mg.
Note
The backup battery is classified as a hazardous substance, Class 9 in accordance with the
relevant air-freight transportation regulations.
For information on handling backup batteries, see Section Fan/battery module (Page 83).
SIMOTION D4x5
Manual, 04/2014
D4x5 environmental requirements
The max. installation altitude for SINAMICS S120 drive components (Motor Modules, etc.) is 4000
m. Details can be found in the
Components Manual.
Values
● -40° C to +70° C
● 0° C to +55° C up to 2000 m above sea level
As of an altitude of 2000 m, the maximum ambient
temperature decreases by 7° C every 1000 m
5 % ... 95 %
Max. 5,000 m above sea level
● Class 1B1 according to EN 60 721‑3‑1
● Class 2B1 according to EN 60 721‑3‑2
● Class 3B1 according to EN 60 721‑3‑3
2 according to EN 60 664‑1
IP20
700 ... 1060 hPa
SINAMICS S120 Control Units and Supplementary System
Technical data
5.1 Technical data D4x5
1)
67