Siemens SIMOTION D4x5 Series Manual page 105

Parameter
Degree of protection according to EN 60529
(IEC 60529)
Atmospheric pressure
Note
The components must be protected against conductive contamination, e.g. by installing them
in a control cabinet with degree of protection IP54 according to IEC 60529 or NEMA 12.
If conductive contamination can be excluded at the installation site, a lower degree of cabinet
protection may be permitted.
See Residual risks of power drive systems (Page 16).
Integrated drive control
Table 7-23
Data
Max. number of axes for integrated drive control
(servo/vector/
Communication
Table 7-24
Data
DRIVE‑CLiQ interfaces
General technical data
Table 7-25
Data
Power supply
● Rated value
● Permissible range
Current consumption, typically
Starting current, typ.
Power loss
With no load on inputs/outputs, no 24 V supply via DRIVE‑CLiQ interfaces
1)
SIMOTION D4x5
Manual, 04/2014
Controls for integrated drives
V / f )
Interface communication
Technical data (general)
1)
Supplementary system components
7.4 Controller Extension CX32
Values
IP20
700 ... 1060 hPa
SIMOTION CX32
6 / 4 / 8 (alternative)
Drive control based on SINAMICS S120 CU320,
firmware version V2.x
SIMOTION CX32
4
SIMOTION CX32
24 V DC
(20.4 ... 28.8 V)
800 mA
1.6 A
20 W
105