Siemens SIMOTION D4x5 Series Manual page 61

Pin
The 1P5 voltage is provided exclusively to supply the bus terminal.
No OLPs are permitted.
Signal type: VO = Voltage output (power supply) O = Output B = Bidirectional
Position of connectors
The following figure shows the mounting position and designation of the connectors on the
Control Unit.
Figure 4-6
Connectable devices
The following devices can be connected to the PROFIBUS DP interfaces:
● PG / PC
● SIMATIC HMI devices
● SIMATIC S7 controllers with PROFIBUS DP interface
● Distributed I/O
● Teleservice adapter
● Drive units with PROFIBUS DP interface (standard slaves)
SIMOTION D4x5
Manual, 04/2014
Signal name Signal type
Position of connectors X126, X136
Note
A teleservice adapter can only be connected to one of the two interfaces.
A detailed, regularly updated list of the modules approved for use with SIMOTION, as well
as notes on their use, can be found on the Internet at
support.automation.siemens.com/WW/view/en/11886029):
Take note of the documentation on the individual modules or devices!
Meaning
(http://
Interfaces
4.6 PROFIBUS DP interfaces
61