Table of Contents
Advertisement
3.3.3.3.1
Frame design
A frame on the STSW-LLL002GUI represents LEDs on the evaluation board in a similar fashion. There are a
maximum of 20 frames (00 to 19) to be set using [Set Frame Count]. To design the frames and demonstrate
them on the evaluation board follow the procedure below.
Step 1.
Click on the LEDs to configure them.
Step 2.
Select the desired brightness using [Frame Brightness].
Step 3.
Press the [Play] button for the STSW-LLL002GUI sequence of frames to visualize the whole pattern to
be displayed on the board.
Step 4.
Set the required transition time between the frames and press [Program].
Note:
Transition time has to be set between 10 to 10000 milliseconds. If a wrong value in entered in the box, the color
of the text box changes to red and no command is sent to the board.
3.3.3.3.2
Using preconfigured frame patterns
In frame programming mode, four preconfigured frame patterns called Presets are provided.
Preset1, Preset2, Preset3 and Preset4 can be loaded by clicking on the corresponding preset button.
UM2381 - Rev 1
Figure 14.
STSW-LLL002GUI frame programming mode
Figure 15.
STSW-LLL002GUI frame programming mode Preset1
UM2381
GUI mode
page 12/29
Advertisement
Table of Contents
Need help?
Do you have a question about the STEVAL-LLL002V1 and is the answer not in the manual?
Questions and answers