Table of Contents
Advertisement
> Touch the icon «Buttonholes».
> Select the Button sew-on Program No. 60.
> Turn the handwheel until the bobbin thread comes up.
> NOTICE! The Button sew-on program always starts above the left hole of the button.
Position the button on the fabric. Place the button and the fabric beneath the needle so that the needle
stitches into the left hole.
For buttons with 4 holes, sew the first front pair of holes first.
> Lower the presser foot.
> Perform the first stitches in the left hole via the handwheel.
> Keep turning the handwheel until the needle changes to the right hole.
Make sure that the needle meets the right hole. If necessary, adjust the stitch width by turning the upper
Multifunction knob.
> Hold the threads and push the foot control.
– The machine sews on the button and stops automatically.
> For increased stability, sew the Button sew-on program again.
> Cut the threads with the machine. Alternatively, pull the sewing projects from under the sewing machine
and trim the threads by hand. Pull the upper thread to the wrong side of the fabric and knot it with the
bobbin thread.
9.17 Sewing eyelets
For increased stability sew the eyelet twice.
Prerequisite:
•
The Reverse pattern foot No. 1C or the Open embroidery foot No. 20C is attached.
> Touch the icon «Buttonholes».
> Select the Eyelet Program No. 61 or No. 62.
> Turn the «Upper Multifunctional knob» or the «Lower Multifunctional knob» to alter the size of the
eyelet.
> Sew the Eyelet Program.
– The machine stops automatically at the end of the Eyelet Program.
> Use an awl, punch pliers or a hole punch to open the eyelet.
Buttonholes
125
Advertisement
Table of Contents
