Table of Contents
Advertisement
Decorative stitches
Inserting the cord
> Switch the machine off and disconnect it from the power supply system.
> Remove the needle.
> Remove the presser foot.
> Remove the stitch plate.
> Open the bobbin cover.
> Pull the cord through the hook opening from the bottom and through the opening of the stitch plate.
> Replace the stitch plate.
> Close the bobbin cover.
> Make sure that the cord slides through the thread slot of the bobbin cover.
> Place the cord spool on the knee lifter.
> Check that the cord runs smoothly.
> If the thread doesn't glide smoothly at the hook cover, leave the hook cover open.
> If the hook cover is opened, deactivate the lower thread indicator in the Setup Program.
Sewing Pintucks
The cord lies on the wrong side of the material and is held/sewn over by the bobbin thread.
> Sewing the first pintuck.
> Place the first pintuck in one of the side grooves in the presser foot.
> Sew additional pintucks parallel.
110
Advertisement
Table of Contents
