Control Wires - Stiga Park 2WD Workshop Manual

Contents in this chapter
6.1 Description ....................................... 2
6.2 General measures ............................ 3
6.2.1 Elbow links .................................... 3
6.3 HST control wire (2WD and 4WD
with int. pump) ........................................ 5
6.3.1 Replacement ................................. 5
6.3.2 Adjustment .................................... 7
6.4 HST control wire (4WD with external
pump) ...................................................... 9
6.4.1 Replacement ................................. 9
6.4.2 Adjustment (4WD with external
pump) ................................................... 10
6.5 Brake/clutch .................................... 11
6.5.1 Senator ........................................ 11
6.5.2 President, Royal, Pro 16, Pro 20, Pro
Diesel ................................................... 14
General
All the manoeuvring functions are incorporated on the control panel. This is an excellent
solution in terms of ergonomics and comfort. It also simplifies the service work since all the
controls and adjustments can be accessed in one place.
All mechanical control movements from the operator to the respective device on the ma-
chine are conducted by wires and in some cases with rods.
These equipments are mainly the same for all the machines covered by this manual, but
in some cases configurated in different ways. Where divergences occour between the
machines, particular instructions are given for each particular equipment.
This chapter gives a brief description of the equipments and describes their repair and re-
placements.
WORKSHOP MANUAL
PARK

6 Control Wires

Chapter
6 - Control Wires
6.6 Replacement of PTO wire .............. 16
6.6.1 Machines with the control panel to
the right ................................................ 16
6.6.2 Compact ...................................... 17
6.6.3 Adjustment of PTO wire and brake 18
EDITION Page
1
2018