6.3 HST control wire (2WD
and 4WD with int. pump)
6.3.1 Replacement
1. Dismantle the control wire.
2. Fit the new control wire. Check that the
wire is fitted in the right direction.
The arrow on the wire casing should
always point forwards.
3. Fit the wire in the rear attachment, and
tighten the screw.
4. Connect the rear elbow link to the centre
hole of the HST lever.
.
WORKSHOP MANUAL
PARK
Chapter
6 - Control Wires
EDITION
Page
5
2018