Stiga Park 2WD Workshop Manual page 82

Procedure
1. Release the stop nuts at the ends of the
wire.
2. The clutch pedal should have a clearance
of 10-15 mm. Adjust if necessary.
3. Activate the parking brake.
The length of the brake arm spring should
be 35 mm when the parking brake is acti-
vated. Adjust if necessary by turning the
nut.
4. Test drive.
A comprehensive test drive is required to
check the function of the brake and trans-
mission.
A. Test the disengaging function by driving
slowly forwards and simultaneously press-
ing down the brake pedal half way. The
machine should slowly stop as the drive
belt is disengaged.
B. Release the clutch and the machine
should start to move forwards again.
Now press the brake fully down, more
quickly than the former test. The machine
should now stop immediately.
C. Now park the machine on a slope and
activate the parking brake.
Switch off the engine. Check that the
machine does not move. If the machine
moves, adjust the parking brake as above.
WORKSHOP MANUAL
PARK
Chapter
6 - Control Wires
EDITION Page
15
2018