Transmission With The Hydraulic Pump In The Rear Axle Drive - Stiga Park 2WD Workshop Manual

4.9.2 Transmission with the hydraulic
pump in the rear axle drive
The oil and filter in the hydraulic power
transmission must be checked/adjusted and
changed at the intervals given in the table
below.
Action
Checking – adjusting
level.
Changing the oil
Cleaning the filter.
The type of oil is dependent on the hours of
operation according to the table below:
Hours of operation
More than 100
hours of operation/
year
Less than 100 hours
of operation/year
Oil quantity when changing: approximately
3.5 litres.
Check – adjustment
1. Place the machine on a flat surface.
2. Read off the oil level in the reservoir. See
the figure. The level should be level with
the line.
3. If necessary, top up with more oil.
Draining
1. Run the machine at variable speeds for
10-20 minutes to heat up the transmission
oil.
2. Position the machine completely horizon-
tally.
3. Pull out both disengagement levers A and
B according to the figure.
WORKSHOP MANUAL
PARK
1st Then at
time
Hours of opera-
tion
-
5
Oil type
Synthetic oil 5W-50
Synthetic oil 5W-50
Chapter
4 - Hydraulic system
inter-
vals of
50
200
EDITION
2018
B A
Page
30