Stiga Park 2WD Workshop Manual page 63

Filling.
The engine must never be run when
the rear clutch release lever is pushed
in and the front clutch release lever is
pulled out.
This will damage the front axle seals.
1. Fill the oil reservoir with the new oil.
If the engine is run indoors, exhaust
extraction equipment must be con-
nected to the engine's exhaust pipe.
2. Check that the rear axle's clutch release
lever is pulled out.
3. Start the engine. When the engine is started,
the front axle's clutch release lever slides
inwards automatically.
4. Pull out the front axle's clutch release lever.
NOTE! The oil is drawn into the system
very quickly. The reservoir must always be
topped up. Air must never be drawn in.
5. Set the accelerator pedal to the forward
position by blocking it using a wooden
wedge. See the figure. Fill the oil reservoir
by hand using new oil.
6. Run in the forward position for one minute.
7. Move the wooden wedge and set the accel-
erator pedal to the reverse position. Con-
tinue filling with oil.
8. Run in reverse mode for one minute.
9. Change driving direction once every minute
as above and continue filling with oil until the
bubbling in the reservoir stops.
10. Switch off the engine, install the oil reservoir
cover and close the engine cover.
11. Test drive for several minutes and adjust
the oil level in the reservoir.
WORKSHOP MANUAL
PARK
Chapter
4 - Hydraulic system
EDITION Page
32
2018