Adjustment (4Wd With External Pump) - Stiga Park 2WD Workshop Manual

6.4.2 Adjustment
(4WD with external pump)
The length of the wire is adjusted by screwing
the elbow links in the desired direction. Per-
form the adjustment at both links. The links
shall be screwed onto the wire about the same
amount. See "Elbow links" at page 3.
1. Set the rear stop screw in its lowest
position.
2. Block up the pedal with a piece of wood or
similar until the pedal rests against its rear
stop. If the pedal doesn´t reach its rear
stop, adjust the elbow links.
3. Check that the pump lever has fully reach
its stop position. If not, adjust the elbow
links.
4. Block up the pedal with a piece of wood or
similar until the pedal rests against its front
stop. If the pedal doesn´t reach its front
stop, adjust the stop upwards.
5. Check that the pump lever has fully reach
its stop position. If not, adjust the elbow
links.
When the control wire is properly adjusted, the
following conditions shall be fulfilled:
• Both elbow links shall be screwed onto the
wire ends about the same amount.
• The pedal shall easily reach its rear stop
(moved backwards). Simultaneously shall
the pump lever reach its stop position.
• The pedal shall easily reach its front stop
(moved forwards). Simultaneously shall
the pump lever reach its stop position.
Warning!
If the pump lever reach its stop and
the pedal not, abnormal push/pull
forces will occour in the wire. This
will limit the wire durability.
WORKSHOP MANUAL
PARK
Chapter
6 - Control Wires
EDITION Page
10
2018