Connecting The Grp2600; Configuration Via Keypad; Figure 4: Grp2600 Back / Side View - Grandstream Networks GRP2612 Administration Manual

Connecting the GRP2600

To setup the GRP2600, follow the steps below:
1. Connect the handset and main phone case with the phone cord.
2. Connect the LAN port of the phone to the RJ-45 socket of a hub/switch or a router (LAN side of the router)
using the Ethernet cable.
3. Connect the PSU output plug to the power jack on the phone; plug the power adapter into an electrical
outlet. If PoE switch is used in step 2, this step could be skipped.
4. The LCD will display provisioning or firmware upgrade information. Before continuing, please wait for the
date/time display to show up.
5. Using the phone embedded web server or keypad configuration menu, you can further configure the
phone using either a static IP or DHCP.

Configuration via Keypad

To configure the LCD menu using phone's keypad, follow the instructions below:
•
Enter MENU options. When the phone is in idle, press the round MENU button to enter the
configuration menu.
•
Navigate in the menu options. Press the arrow keys up/down/left/right to navigate in the menu options.
•
Enter/Confirm selection. Press the round MENU button or "Select" Softkey to enter the selected
option.
•
Exit. Press "Exit" Softkey to exit to the previous menu.
•
Return to Home page.
In the Main menu, press Home Softkey to return home screen.
In sub menu, press and hold "Exit" Softkey until Exit Softkey changes to Home Softkey, then release
the Softkey.
•
The phone automatically exits MENU mode with an incoming call, when the phone is off hook or the
MENU mode if left idle for more than 60 seconds.

Figure 4: GRP2600 Back / Side View

GRP26XX Administration Guide
P a g e |
18