Maintenance Page Definitions; Table 11 : Maintenance Page Definitions - Grandstream Networks GRP2612 Administration Manual

(1 - 10) Password
Security
Type

Maintenance Page Definitions

Maintenance → Web Access
New Password
Confirm Password
Current Password
New Password
Confirm Password
Maintenance → Upgrade and Provisioning
Upgrade Firmware
Firmware Upgrade and
Provisioning
Always Authenticate
Before Challenge
Allow DHCP Option 43
and Option 66 Override
Server
Additional Override
DHCP Option
Allow DHCP Option
120 to override SIP
Server
3CX Auto Provision
Configures the authentication password to access WiFi Network.
Specifies the WiFi encryption type. The available options are the
following: None, WEP, WPA, WPA Enterprise and Auto. Default
settings is None.

Table 11 : Maintenance Page Definitions

Set new password for web GUI access as User. This field is case sensitive.
Enter the new User password again to confirm.
The current admin password is required for setting a new admin password.
Set new password for web GUI access as Admin. This field is case sensitive.
Enter the new Admin password again to confirm.
Allows users to upload the firmware file locally by pressing Start, after
selecting the correct firmware file from the local storage, the phone will start
the firmware upgrade automatically.
Specifies how firmware upgrading and provisioning request to be sent:
Always Check for New Firmware, Check New Firmware only when F/W
pre/suffix changes, Always Skip the Firmware Check.
The default setting is "Always Check for New Firmware".
Only applies to HTTP/HTTPS. If enabled, the phone will send credentials
before being challenged by the server. The default setting is "No".
Default setting is "Yes". DHCP option 66 originally was only designed for
TFTP server. Later on, it was extended to support an HTTP URL. GRP
phones support both TFTP and HTTP server via option 66. Users can also
use DHCP option 43 vendor specific option to do this.
DHCP option 43 approach has priorities. The phone is allowed to fall back
to the original server path configured in case the server from option 66 fails.
When enabled, users could select Option 150 or Option 160 to override the
firmware server instead of using the configured firmware server path or the
server from option 43 and option 66 in the local network. Please note this
option will be effective only when option "Allow DHCP Option 43 and Option
66 to Override Server" is enabled. The default setting is "None".
Enables DHCP Option 120 from local server to override the SIP Server on
the phone. The default setting is "No".
Enables automatic provisioning feature on the phone when 3CX is used as
the SIP server. The default setting is "Yes".
GRP26XX Administration Guide
P a g e |
78