Insert/Remove Iot Modules - mangOH green User Manual

mangOH green User Guide
Rev 2 Jan.16

Insert/Remove IoT Modules

The mangOH green includes three single-width IoT module slots.
If the board uses module mounting rails and you want to use a double-width
(2-slot) or triple-width (3-slot) IoT module, remove the rails between the slots you
will be using.
Caution: Handle IoT modules carefully to make sure components are not accidentally
damaged, and hold modules by their edges to avoid possible ESD damage.
To install an IoT module in any IoT slot:
1. Remove power from the mangOH green. (This step is recommended in case
the IoT module is not hot-swappable or needs a reset.)
2. Check the IoT module to make sure you know which side is the top. (Modules
must not be inserted upside-down.)
3. Slide the IOT module into the rails until it meets the connector, then press
firmly to seat the module into the connector.
Figure 3-20: IoT Module Insertion
22 4117164