Honeywell MeshGuard FTD-2000 User Manual page 42

Next, place the MeshGuard into the enclosure:
1. Lift up the hinged cover of the enclosure.
2. Slide the MeshGuard into the enclosure from the top.
3. Close the cover of the enclosure.
4. Insert the hex screw into the cover's locking portion, and tighten it.
5. The MeshGuard is now ready to use.
Note: The sensor cover on the bottom of the enclosure can be removed so that the filter and sensor can be
inspected without removing the MeshGuard from the enclosure. Simply pull off the cover and follow the
maintenance procedures in this guide.
MeshGuard User's Guide
1 2 3 4
42
5