2.4 Terminal Resistor Jumper Selection
Remove the cover of the I-7188XBD-CAN/μPAC-7186EXD-CAN. Users
can see the part of internal structure shown as following figure. The XC100
provides users one jumper-selected termination resistor (J3). Its position is
displayed below.
Figure2.1
The jumper J3 is used to judge the resister of CAN network. When users
want to set the jumper JP3, the upper cover of I-7188XBD-CAN/
μPAC-7186EXD-CAN needs to be removed. About the J3 jumper setting,
please refer the following figure.
I-7188XBD-CAN/μPAC-7186EXD-CAN user manual (ver.1.0.3, May/09/2014)
XC100 I/O expansion board LAYOUT
13