Summary of Contents for ICP DAS USA MP-8 43 Series
Page 1
MP-8x43 Getting Started V 1.0 MP-8x43 Getting Started V1.0 1 http://www.icpdas.com...
Page 2
A English Version 1.1 hardware setup and basic setting In this section we will introduce for basic setting for WinCE and use the EzConfig tools to test the digital IO. 1.1.1 MP-8x43 wire connection The main hardware of MP-8343 is showed as below. It includes VGA,USB, Compact Flash, COM Port, Ethernet and interface for I/O modules。...
Page 3
1.1.2 Quick hardware setup What’s on your package? Item Quantity Model No. Description MP-8343 MP-8343: 3 slots MP-8000 MP-8743: 7 slots MP-8743 Quick Start Guide Manual (this manual) CF Card Rescue CF Card Software and documents included. 2.4 mm Screw Screw Driver 1C016 driver...
Page 4
6. Setup: 1. Plug the USB mouse into USB interface. 2. Plug the I/O Modules into I/O slot, and make sure that was installed correctly. 3. Connect the monitor VGA cable to MP-8000 VGA port, and connect monitor power cable to properly power source and turn it on . 4.
Page 5
After power-on and boot up the monitor will show as below: 1.1.3 Windows CE system basic setting Setting the Date and time : use the mouse select “start” Setting(S) Control Panel(C), Open the Control Panel。 Double click “Date/Time” icon, Open the dialog。 After setting the date and time, please click the “Apply"...
Page 6
Setting the IP address for Ethernet: If use the DHCP you don’t need to read this section. Setect “Start” Setting(S) Network and dial-up Connections (N). Double click “PCI-FETCE5B1/2” icon,show the Ethernet Adapter setting dialog. selected “Specify an IP Address(S)”,and set the IP Address位址(A),Subnet Mask(U ),default gateway(G).
Page 7
1.2 Easy test for digital IO module Open the EzConfig Click the Start->programs->ICPDAS->E zProg-I->EzConfig Will show the EzConfig main dialog: 1 => click the Scan Slot button 2 => and select “Yes” EzConfig will find out all modules that had been plugged in the slots automatically.
Page 8
3 => use the mouse click the module in monitor. That will show the module IO status. 4 => The Y(DO) that you can click that to control the output on/off status. Show I-8054W as below: 5 =>Click the Y0,Y1,Y2,Y3 as ON 6 =>...