Table Of Return Code - ICP DAS USA mPAC-7186EXD-CAN User Manual

3.2 Table of Return Code

Return
Error ID
Code
0 CAN_NoError
5 CAN_ResetError
8
CAN_ConfigError
9 CAN_SetACRError
10 CAN_SetAMRError
11
CAN_SetBaudRateError
14 CAN_InstallIrqFailure
15 CAN_RemoveIrqFailure
16
CAN_TransmitIncomplete
17 CAN_TransmitBufferLocked
18
CAN_ReceiveBufferEmpty
19 CAN_DataOverrun
20 CAN_ReceiveError
21 CAN_SoftBufferIsFull
22
CAN_SoftBufferIsEmpty
23 CAN_BaudNotSupport
24
CAN_DataLengthError
25 CAN_NotEnoughMemory
26 CAN_TypeOf7188Error
50 CAN_AutoBaudTimeout
51 CAN_TxBufferNotZero
52 CAN_BusOff
I-7188XBD-CAN/μPAC-7186EXD-CAN user manual (ver.1.0.3, May/09/2014)
Comment
OK
Enter reset mode error
CAN chip configure error
Set to Acceptance Code Register error
Set to Acceptance Mask Register error
Set Baud Rate error
Enable interrupt functions failure
Disable interrupt functions failure
Data can't be transmitted successfully
Previously transmission is not completed yet
No message is stored in the receive buffer
now
Data was lost because there was not enough
space in software receive buffer
Receive data is not completed
Software transmit buffer is full
There is no message
user-declared software buffer
This Baud Rate is not supported
Data length doesn't match the total data
bytes
There is not enough memory space to create
the reception or transmission software buffer.
The type of 7188 is not defined by this library
CAN bus baud rate not found
If the transmission buffer is not disabled, this
error code will be returned after calling
SendCANMsg_NonBlock.
When CAN Bus status become "Bus Off",
this error code will be return.
stored in the
49