TRENDnet TEW-740APBO Quick Installation Manual page 17

2. Re-install the cover by lining up the guides into the notches as shown and push the cover
down until the cover clips in and is secure.
3. Insert the included fasteners through the holes located at the back of the access point.
4. Wrap the fasteners around the pole where the access points will be installed. On the
fasteners, insert the open end into the locking mechanism and pull tight until the access
point is secured.
5. After the access points are properly mounted, you can connect the grounding wires to the
proper ground points and RJ-45 cables from each access point to your network.
15