TRENDnet TEW-740APBO Quick Installation Manual page 5

Phase 2: TEW-740APBO Unit #1 Hardware Setup and Configuration
1. Remove the cover of the access point by pulling and holding the tab in the vertical direction
upward (based on the access point orientation below) and sliding the cover in the two
locations noted below away from the access point.
2. Write down the MAC address (WiFi MAC) of the TEW-740APBO #1 access point. The MAC
address (WiFi MAC) can be found on the inside of the device cover where the Ethernet LAN
ports are located (shown below).
WIFI MAC: XXXXXXXXXXXXXXXXX
ETH LAN1 MAC: XXXXXXXXXXXXXXXXX
Model No: TEW-740APBO / A S/N: XXXXXXXXXXXXXXX
H/W: V2.0RFW: V2.XXXXX
Made in XXXXXX
3
Pull and hold tab