Carrier AquaForce 30XV140 Controls, Start-Up, Operation, Service And Troubleshooting Instructions page 7

MESSAGE
COMMUNICATION FAILURE!
ACCESS DENIED!
LIMIT EXCEEDED!
COMMAND ACCEPTED
HIGHER FORCE IN EFFECT!
Save changes?
Invalid password!
Log level = basic
Log level = User
Log level = Service
Log level = Factory
PLEASE LOGIN
Select Machine Mode
Machine Status
Loading Data ...
TRENDING FIRMWARE MODULE ERROR!
BACNET FIRMWARE MODULE NOT FOUND!
Too Many users connected! Please try again later ...
Application Firmware must be downloaded!
Table 4 — Status Messages
Equipment controller did not respond while reading the table content.
Equipment controller denies access to one of the tables. See Touch Pilot Login and
Display Setup, page 8.
The value entered exceeds the parameter limit.
Force or Auto command was accepted by the Equipment Controller.
Equipment controller rejects Force or Auto command.
Modifications have been made. The exit must be confirmed by pressing Save or Cancel.
Entered password is not valid
Entered password is 0 = basic, login is allowed
Entered password corresponds to the User password, login is allowed
Entered password corresponds to the Service password, login is allowed
Entered password corresponds to the Factory password, login is allowed
Login required before accessing start/stop function
Default prompt when entering the Start/Stop screen.
Application status message (see somewhere else)
Trend Manager is not ready yet.
Trend Manager detected a problem during its initialization sequence (file access or file
content problem) and cannot display Trend/Log data.
BACNet module is not responding (its web server is not functional, or the whole module
failed to start).
Maximum of 2 concurrent web server connections allowed.
The software detected a conflict between the version of the web server web pages, and
the HMI application firmware.
7
STATUS