Carrier AquaForce 30XV140 Controls, Start-Up, Operation, Service And Troubleshooting Instructions page 110

ALARM
CODE
9001 Lag_pump control is selected while pump configuration is disabled
9002 Master and Slave have the same address
9003 No Slave configured
9004 Slave Lag_pump is selected while slave pump configuration is disabled
9005 Master and Slave will have the same water control type
9006 Master and Slave will have the same water control type
9007 Master lag pump control is configured
9008 Master lag pump control is not configured
9009 The slave demand_limit or chil_s_s or control point or setpoint is forced with force < 4 (chilstat == 3 updated by fsm_sub(), set
M_MSTSLV maintenance table master slave error = 4 and slave_enable to FALSE and UNIT NOT FAILED)
9010 The slave demand_limit or chil_s_s or control point or setpoint is forced with force < 4 (chilstat == 3 updated by fsm_sub(), set
M_MSTSLV maintenance table master slave error = 4 and slave_enable to FALSE and UNIT FAILED)
9011 Unit is not in CCN mode
9012 Communication between Master and Slave has been lost for more than 2 minutes
9013 Master and Slave Heat/Cool selection conflict
9014 Master and Slave parallel and series selection conflict
9015 Master and Slave EWT option in conflict with chiller in series
9016 Slave EWT option in conflict with chiller in series
LEGEND
CCN — Carrier Comfort Network®
EWT — Entering Water Temperature
Table 74 — Master/Slave Alarm Codes
ALARM DESCRIPTION
110