Carrier AquaForce 30XV140 Controls, Start-Up, Operation, Service And Troubleshooting Instructions page 177

Operating Data:
Record the following information from the Run Status, Temperatures and Outputs Modes when machine is in a
stable operating condition.
TEMPERATURES
EVAPORATOR ENTERING FLUID _______________
EVAPORATOR LEAVING FLUID
CONTROL POINT
CAPACITY
OUTSIDE AIR TEMPERATURE
CHWS TEMPERATURE
CIRCUIT A
SATURATED COND TMP CIRC A __________ SATURATED COND TMP CIRC B __________
SATURATED SUCTION TEMP A
SATURATED LIQUID TMP A
COMPRESSOR SUCTION TMP A
DISCHARGE GAS TEMP CIR A
MOTOR TEMPERATURE CIR A
EXV ECO. TMP CIR A
LIQUID TEMPERATURE A
COMPRESSOR MOTOR CURRENT
L1
COMPRESSOR A1_______ _______ _______
COMPRESSOR B1_______ _______ _______
CONDENSER FAN MOTOR CURRENT
L1
FAN MOTOR A1 ____ ____ ____ FAN MOTOR B1
FAN MOTOR A2 ____ ____ ____ FAN MOTOR B2
FAN MOTOR A3 ____ ____ ____ FAN MOTOR B3
FAN MOTOR A4 ____ ____ ____ FAN MOTOR B4
FAN MOTOR A5 ____ ____ ____ FAN MOTOR B5
FAN MOTOR A6 ____ ____ ____ FAN MOTOR B6
FAN MOTOR A7 ____ ____ ____ FAN MOTOR B7
FAN MOTOR A8 ____ ____ ____ FAN MOTOR B8
FAN MOTOR A9 ____ ____ ____ FAN MOTOR B9
FAN MOTOR A10 ____ ____ ____ FAN MOTOR B10
HEATER CURRENT
EVAPORATOR HEATER CURRENT
OIL SEPARATOR HEATER CURRENT CIRCUIT A
OIL SEPARATOR HEATER CURRENT CIRCUIT B
_______________
_______________
_______________
_______________
_______________ (Dual Chiller Control Only)
__________ SATURATED SUCTION TEMP B
__________ SATURATED LIQUID TMP B
__________ COMPRESSOR SUCTION TMP B
__________ DISCHARGE GAS TEMP CIR B
__________ MOTOR TEMPERATURE CIR B
__________ EXV ECO. TMP CIR B
__________ LIQUID TEMPERATURE B
L2 L3
L2 L3
CIRCUIT B
L1 L2 L3
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
__________
__________
__________
CL-7
__________
__________
__________
__________
__________
__________
__________