Lfpt Dip Switches; Led Operation - Advantech B+B SmartWorx PoE Giga-McBasic User Manual

LFPT DIP SW ITCHES
The DIP Switches for LFPT allows a LOS fault to be passed through the unit.
When enabled, if link is lost on the FX port, the transmit on the TX port is
disabled. If link is lost on a TX port, the transmit on the FX Port is disabled.
NOTE: With the fault switches – PoE Reset, LFPT Port 1 and LFPT Port 2, only one fault condition is
recognized at a time. The first fault condition is in charge. So, if TX Port 1 has no link and then the FX Port loss
link, the loss of TX Port 1 link causes the FX Port to disable transmit.

LED OPERATION

The PoE Giga-McBasic LFPT includes LEDs for three ports, as shown below:
PoE Giga-McBasic LFPT SFP
SFP LED Functions
FLT
LNK
1000 Mbps
PWR
RJ-45 LED Functions
LNK/ACT (TX1, TX2)
PSE (TX2)
FDX (TX1)
PoE & PoE+ Giga-McBasic
Glows red when a fault has been detected on the unit.
Glows green with a valid link.
Glows green when SFP is running at 1000Mbps.
Glows green when unit is powered.
Glows green with a valid link.
Blinks green when activity is detected.
Glows green when port is supplying PoE power.
Blinks green during fault conditions: 1 Hz flashes to indicate an overload or
short; 4 Hz flashes to indicate out-of-range voltage or over-temperature.
Off if the port is not supplying power.
Glows amber when port is running full-duplex.
6
LFPT