Daily Maintenance; After-Season Maintenance And Storing Of Machine - SaMASZ KDT 180 Operator's Manual

S
O
Fig. 32a. Rollers transmission guard
Fig. 32c. Conditioner roller transmission
guard

6.9.4. Daily maintenance

When you finish each day of operation carry out the following maintenance:
check all visible parts and components and their connections; tighten all loose bolts and nuts
and replace all damaged and/or worn parts with new genuine ones,
clean the mower, especially between discs and cutterbar, because grass with mud may damage
bearings in disc module,
remove grass and mud,
check the cutterbar,
grease PTO shaft tubes with STP grease,
if necessary, lubricate the parts and components according to lubrication instructions (chapter7).
Parts which may cause risk to operator's health and safety are as follows: damaged discs, missing or
damaged safety covers, worn or damaged hydraulic hoses, PTO shaft guides, worn knives and knife
holder pins.

6.9.5. After-season maintenance and storing of machine

At the end of mowing season the following shall be performed:
lower the mower's cutterbar onto the ground,
take the PTO shaft extension out of the tractor rpm or dismount the complete PTO shaft and
install it into corresponding holder at the 3-point linkage frame,
unmount hydraulic and electrical hoses from the tractor and hang them onto corresponding
holders on the 3-point linkage frame,
Operator's manual
- 34 -
Rear disc mowers
N
Fig. 32b. Adjusting tension of transmission
toothed belt
Fig. 32d. Adjusting tension of toothed belt for
conditioner roller transmission
KDT