Operating Positions Of The Mower - SaMASZ KDT 180 Operator's Manual

tighten the cord until the lock Z is released (Fig. 10a) and by means of hydraulic cylinder put
the mower into horizontal position,
with tractor's lever lower the cutterbar to reach the horizontal position in a possibly slow way,
lower the mower until the support chain tightens. If the 3-point linkage frame is more than
1' 4" above the ground, adjust the chain.
By means of link S (Fig. 8) adjust the cutting height. Extending the link S increases the cutting
height and shortening the link reduces it.
The proper distance between the end of cutterbar and tractor's tyre Y should be about 0 to 4" for
KDT 180, KDT 220, KDT 260. For KDT 300 Y should be between 11.8" and 1' 4. For KDT 340,
KDT 341 between 1' 8" and 1' 12".

5.5.1. Operating positions of the mower

Operator's manual
Y
Fig. 13. Proper distance between the cutterbar and tyre
max. 30º
Fig. 14. Operating positions of the mower
- 21 -
Rear disc mowers
KDT
For KDT 180; KDT 220;
KDT 260
Y = from 0 to 4"
For KDT 300
Y = from 11.8" to 1' 4"
KDT 341
For KDT 340;
Y = from 1' 8" to 1' 12"
max. 30º