Disassembly And Withdrawal From Use; Scrapping; Warranty Card; Warranty Terms - SaMASZ KDT 180 Operator's Manual

9. DISASSEMBLY AND WITHDRAWAL FROM USE

9.1.

Scrapping

If the mower cannot be repaired anymore, it should be withdrawn from use
To do so, oil from intersecting axis gear and cutterbar should be drained and delivered to a
proper waste treatment company. Clean the mower parts, dismantle and dispose properly of all
plastic parts. After that, the mower can be scrapped.

10. WARRANTY CARD

The product quality has been checked and meets the required standards and regulations and is
permitted for use.
NOTE:
A warranty card without the required information or with corrected or illegible
information – is invalid.

11. WARRANTY TERMS

11.1. Warranty claims procedures

1. The manufacturer guarantees its products against faults in materials or production.
2. The warranty period is for two years from the date of sale to the purchaser, stated above.
3. Any repair which is subject to warranty should be carried out by an authorised SaMASZ dealer.
Upon completion of the repair the dealer must submit a warranty claim within 14 days.
4. Warranty claims regarding replacing of the product or repayment are considered within 14 days
by the manufacturer.
5. The following cases are not covered by warranty:
a) wearing parts: mowing discs, sliding skids, sidle bushings Pcw, intersecting axis gears
and parts inside the gearboxes, bushings and sliding elements, joints, knife holders,
cutting knives, V-belts, chain gears, drivechain, conditioner's tines and rollers, roller
conditioner's rubbers, bearings, rubber-metal fenders, safety curtains, conveyor's
belts, swath guides rubbers, connective elements, etc.
These repairs may be done only at purchaser's cost.
b) use for any other purpose than those described in the operator's manual,
c) operation on stoney fields and results such as: damage of tine conditioner's shaft, discs,
bending of cutterbar (stone with its diameter of 5.5" will not move between the discs
and conditioner's shaft,
d) running into any obstacle,
e) too fast lowering of the cutterbar to the ground,
Operator's manual
REAR DISC MOWER
- 39 -
Rear disc mowers
KDT
.
Serial number
Date of manufacture
Manufacturer's stamp
QC signature
Date of purchase
Dealer's stamp
Dealer's signature