Settings; General Network Settings - Vidicode V-Tap VoIP Manual

Hide thumbs Also See for V-Tap VoIP:

Table of Contents

3.3 Settings

The settings are divided into groups that are described in the following

paragraphs.

3.3.1

Device Name

This field can be filled in with any name you like and is used for

remote recognition of the V-Tap unit. The name is shown in the

settings web interface and after connecting with ftp or telnet. The

name is not used in the Tunnel protocol. The maximum length is 30

characters. Example are "Richard Phone" or "SalesTrunk".

DHCP Server

Default, the DHCP feature is not enabled and the V-Tap unit has a

fixed IP address. When a DHCP server is available on the network and

is used, the IP and Gateway addresses are automatically assigned.

Without DHCP you must manually enter an IP address.

Device IP Address

As part of the network, the V-Tap VoIP needs an IP address. In case a

DHCP server is used, the DHCP server will assign the V-Tap VoIP an IP

address. In case a DHCP server is not used, a static IP address must be

filled in. The default static address is "192.168.55.66".

Subnet Mask

The IP mask is used for so called 'subnetting', a way to logically

divide one network into more networks. The logical AND of the IP

address with the IP mask must be the same for the device and the

computer connecting to it.

More explanation can be found on the internet and is out of the

scope of this manual.

Gateway Address

The Gateway address is used by the V-Tap VoIP unit when access

outside the local network (LAN) is required. This sort of access can be

Table of Contents