Table of Contents
Advertisement
Altera Corporation
July 2010
Create a BSP
The first thing that's needed to build the software project is a board
support package (BSP). To create a BSP perform these steps:
1.
Open a Nios II Command Shell.
2.
Change to the directory:
<Install Directory>
examples/
application_selector/
software_examples/
bsp/
hal_application_selector
3.
Run the command ./create_this_bsp.
Build the project
The next step is to build the Application Selector project. To build the
project, perform these steps:
1.
In the Nios II Command Shell, change to the directory:
<Install Directory>
examples/
application_selector/
software_examples/
app/
application_selector
2.
Run the command make all.
1
For more information about BSPs and the Nios II Software
Build Tools, refer to the
Line
chapter in volume 2 of the Nios II Software Developer's
Handbook.
Getting Started from the Command
Nios II Embedded Evaluation Kit, Cyclone III Edition
B–8
Advertisement
Table of Contents
Need help?
Do you have a question about the Nios II Embedded Evaluation Kit Cyclone III Edition and is the answer not in the manual?
Questions and answers