Figure 70 - Location Of S2 Dip Switches - Keyscan CA250 Series Technical Manual

S2 Switch # Setting
The H2 header for CIM connections is an open header not regulated by S2.
S2.9 & S2.10
n/a
S2.11 & S2.12
1 1
0 0
1 0
0 1
0 = Off
1 = On
Notes on Communication Settings
The 9600 bit/s communication setting is recommended for the CPB-10-2 only. Aurora does not support
this communication setting.
The 19,200 bit/s communication setting is recommended only for CPB-10-2 connections, which do not
exceed 200 ft/61 m between units and overall distance.
Aurora and all current hardware products do not support modem communication.
Ensure you are running the most current software version with this control board. For the latest software
updates, visit www.keyscan.ca.
Cut View of CA8500B
KI-00143E-04-13
Keyscan Inc. – Technical Guide (PC109x - 07.15)
Function
KHS - IP Address
Reserved for Keyscan Hosted Services
Software Selection
Aurora
System VII
Vantage
Future use
Figure 70 – Location of S2 DIP Switches
READER 5 READER 4
Location of S2 is the
same on all CA & EC
control boards.
Protective ACU Cover
COMMUNICATION STATUS
TD1 RD1 TD2 RD2 TD3 RD3 TD4 RD4
Notes
READER 3 READER 2 READER 1
S3
S2
S1
94