S2 Dip Switch Settings; Table 14 - S2 Dip Switch Settings - Keyscan CA250 Series Technical Manual

S2 DIP Switch Settings

Review Table 14 for determining S2 DIP switch settings.
S2 Switch # Setting
0 = Off
S2.1
1 = On
0
0
1
S2.2 & S2.3
0 0
1 0
0 1
1 1
S2.4 & S2.5
0 0
0 1
1 0
1 1
S2.6
0
1
S2.7 & S2.8
0 0
0 1
1 0
1 1
Keyscan Inc. – Technical Guide (PC109x - 07.15)
Table 14 – S2 DIP Switch Settings
Function
Communication Mode
Serial Communication
Network Communication
Reverse Network Communication
Communication Bit Rate
9600 bit/s
19,200 bit/s
57,600 bit/s (CPB-10-2 not supported)
115,200 bit/s (CPB-10-2 or CB-485 not
supported)
Alternate Panel Serial # Selection
Factory-assigned serial # *
Alternate serial #1 – adds 1000 to factory-
assigned serial #
Alternate serial # 2 – adds 100 to factory-
assigned serial #
Alternate serial # 3 – adds 10 to factory-assigned
serial #
Lockdown
Disabled
Enabled
Communication Terminal Block Activation
For direct serial communication connect to RS-
232 (COM4) - TB4 terminal block
CB-485 and CPB-10-2 communication via CPB/CB
MODULE (COM4) - H1 header
NETCOMP communication plugged directly into M1
on control board (COM4)
Program mode for NETCOMP plugged into M1
(COM4) on the control board
Notes
Also see S2.7 & S2.8 in the table.
As above.
Applies only to the reverse network
designated control board with the
programmed IP of the host
location. All other boards on
communication bus S2.1 = 0. Also
see S2.7 & S2.8 in the table.
(not applicable for reverse network)
Recommended setting
(not applicable for reverse network)
* Leave on factory assigned setting
unless prompted in the Client
software when inputting panel data.
(not supported on Aurora)
(not supported on Aurora)
(not supported on Aurora)
CA250 – AI #8 / CA4500 & CA8500
– AI #16 are dedicated lockdown
aux inputs when the control board
is lockdown enabled.
93