Figure 53 - Hid 5355 Wiring - Keyscan CA250 Series Technical Manual

Yellow (Beeper) used for pre-alert
otherwise isolate and tape back.
If connecting external sound device,
see Pre-Alert Relay Option or refer to
ACU cut sheet enclosed with panel
for ACU/OCB8 relay assignments.
Note - If Pre-alert is connected,
the reader cannot read any
HID 125 kHz-compatible card
during the pre-alert beep.
ACU Ground
Lug
Red
Black
VDC
to separate DC
power
supply
KI-00203E-07-11
Notes on HID 5355
The HID 5355 is suitable for indoor and outdoor use. Maximum read range at 12VDC – ProxCard II card is
9" (22 cm) – ISO ProxII card is 8" (20 cm).
Keyscan Inc. – Technical Guide (PC109x - 07.15)
Figure 53 – HID 5355 Wiring
Shield
+
C1 LED D1
(BEEP) WHT
Reader terminal on control board
Shield not connected.
Isolate with electrical tape.
6 conductors shielded 22 AWG
500 ft (152.4 m) maximum
D0 PWR GND
GRN RED BLK
74