Mira Agile S B97C Installation And User Manual page 15

7
Screw
Integrated
Spirit Level
Ensure the pipes do not
push back into the wall.
Loosen the screws and remove the spirit
level and refit the pipe shroud to ensure the
pipes are aligned. Make sure the pipes do
not push back into the wall.
9
Retaining
Screw
Remove the two external retaining screws.
Use a suitable pair of pliers to remove the backplate from the valve, holding where shown.
Remove the retaining screw from the backplate.
Pipe
Shroud
Retaining
Screw
Backplate
15
8
Pipe
Retaining
Screws
Hex Key
To prevent the possibility of property water
damage the screws MUST be tightened
YOU MUST FULLY TIGHTEN the pipe
retaining screws to clamp the pipes. Failure
to do so may result in water damage to your
property. Remove the pipe shroud.
Note: Only suitable for 15 mm pipe.
Retaining
Screw
1285246-W2-D