Cypress PSoC CY8CPROTO-063-BLE Quick Start Manual page 6
6 ble prototyping board
Hide thumbs
Also See for PSoC CY8CPROTO-063-BLE:
- Quick start manual (3 pages) ,
- Quick start manual (3 pages)
Table of Contents
Advertisement
General Safety Instructions
ESD Protection
ESD can damage boards and associated components. Cypress recommends that you perform
procedures only at an ESD workstation. If such a workstation is not available, use appropriate ESD
protection by wearing an anti-static wrist strap attached to the chassis ground (any unpainted metal
surface) on your board when handling parts.
Handling Boards
The CY8CPROTO-063-BLE PSoC 6 BLE Prototyping Board is sensitive to ESD. Hold the board only
by its edges. After removing the board from its box, place it on a grounded, static-free surface. Use a
conductive foam pad if available. Do not slide board over any surface.
PSoC® 6 BLE Prototyping Board Guide, Doc. # 002-24993 Rev. **
6
Advertisement
Table of Contents
Need help?
Do you have a question about the PSoC CY8CPROTO-063-BLE and is the answer not in the manual?
Questions and answers