Cypress PSoC CY8CPROTO-063-BLE Quick Start Manual page 25

6 ble prototyping board

Hide thumbs Also See for PSoC CY8CPROTO-063-BLE:

Table of Contents

Next from the list of devices, select the CYBLE-416054-02 device from the list.

Figure 4-6. Device Selector Wizard

8. On the left-hand side in the Workspace Menu, select the "Pins" option under the "Design Wide

Resources" tab. The Pins tab will appear on the right as shown, see

code example was originally created for a different board, you will need to reassign the LED pins

to be compatible with the CY8CPROTO-063-BLE Prototyping Board. Make the following assign-

ments.

a. Advertising_LED => P7[1]

b. Alert_LED => P6[3]

c. Disconnect_LED => P9[4] (This one is not used for this kit since there are only 2 LEDs. It can

be assigned to any unused pin.)

Figure 4-7. Pin Selection / Reassignment

9. Build and program the project as described in the

6 MCU on page

PSoC® 6 BLE Prototyping Board Guide, Doc. # 002-24993 Rev. **

19.

Figure

Programming and Debugging the Target PSoC

Code Examples

4-7. Because this

Table of Contents

Need help?

Do you have a question about the PSoC CY8CPROTO-063-BLE and is the answer not in the manual?