Assembly; Remove The Generator From The Shipping Carton; Install The Wheel Kit; Install The Support Leg - Champion 100203 Owner's Manual & Operating Instructions

ASSEMBLy

Your generator requires some assembly. This unit ships
from our factory without oil. It must be properly serviced
with fuel and oil before operation.
If you have any questions regarding the assembly of your
generator, call our help line at 1-877-338-0999. Please
have your serial number and model number available.

Remove the Generator from the Shipping Carton

1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the
generator.
3. Carefully cut each corner of the box from top to
bottom. Fold each side flat on the ground to provide a
surface area to install the wheel kit and support leg.

Install the Wheel Kit

CAUTION
The wheel kit is not intended for over-the-road use.
1. Tip the generator slowly so that the engine side is up.
2. Slide the wheel pin roll through the wheel from
the outside.
3. Slide the wheel pin roll through the mount point on
the frame.
4. Secure with the "R" Shape Pin.
5. Repeat steps 2-4 to attach the second wheel.
9

Install the Support Leg

1. Attach the support leg to the generator frame with
flange bolts (M8x16) and flange lock nuts (M8).
2. Tip the generator slowly so that it rests on the
wheels and support leg.

Connect the Battery

1. Remove the protective cover from the red (+) lead on
the battery.
2. Attach the red (+)lead to the red (+) terminal on the
battery with the flange bolt (M5x10) and secure with
the flange nut (M5).
3. Repeat steps 1-2 for the black (–) battery lead.
100203
ENGLISH