Add Engine Oil - Champion 100203 Owner's Manual & Operating Instructions

100203
ENGLISH

Add Engine Oil

CAUTION
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil. Damage to the generator as
a result of failure to follow these instructions will
void your warranty.
NOTE
The generator rotor has a sealed, pre-lubricated ball
bearing that requires no additional lubrication for
the life of the bearing.
NOTE
The recommended oil type is 10W-30 automotive oil.
1. Place the generator on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Add up to 1.1 L (1.2 qt.) of oil (not included) and
replace oil fill cap/dipstick. DO NOT OVERFILL.
4. Check engine oil level daily and add as needed.
NOTE
Once oil has been added, a visual check should show
oil about 1-2 threads from running out of the fill hole.
If using the dipstick to check oil level, DO NOT screw
in the dipstick while checking.
Add Engine Oil Cont'd.
NOTE
Check oil often during the break-in period. Refer to the
Maintenance section for recommended service intervals.
CAUTION
The engine is equipped with a low-oil shut-off and
will stop when the oil level in the crankcase falls
below the threshold level.
NOTE
We consider the first 5 hours of run time to be the
break-in period for the unit. During the break-in
period stay at or below 50% of the running watt
rating and vary the load occasionally to allow stator
windings to heat and cool. Adjusting the load will
also cause engine speed to vary and help seat
piston rings. After the 5-hour break-in period,
change the oil.
Degrees Celsiusº (Outside)
Full Synthetic 5W-30
Degrees Fahrenheitº
NOTE
Weather will affect engine oil and engine
performance. Change the type of engine oil used
based on weather conditions to suit the engine
needs.
NOTE
Synthetic oil may be used after the 5-hour initial
break-in period. Using synthetic oil does not
increase the recommended oil change interval.
ASSEMBLy
(Outside)
10