I Nstall The Sliding Rails And Place Device In Rack; 2: I Nstall In Rack - Promise Technology Vess A3120 Quick Start Manual

Promise Technology
I
nstAll the slIdIng rAIls And plAce devIce In rAck
Follow these steps to install the sliding rails in the rack system, then place the Vess
A3120 onto the rails and secure the device to the rack.
Note
The sliding rail assembly is required for rack installation. The
hardware is available for purchase. Contact your sales representative
if you plan to install this system in an equipment rack.
2: I
nstall In rack
Before installing the VTrak enclosure in the rack, first re-
move the drive carriers with the hard disks installed to re-
duce the weight of the enclosure.
To install the VTrak J5300/J5320 1U subsystem into a rack
with the supplied mounting rails:
1. Determine what height to place the 1U enclosure
in the rack, then place the right and left rack rails
at the same height on in the right and left rack
Lock release lever (back left)
Determine which holes to use on rack
8
Quick Installation Guide