Siemens SIMATIC PCS 7 Operating Manual page 203

Calling a mapping table
1. Open the properties of a control module.
2. Select the "Attributes > Automation Interface" tab.
3. Click the "Open mapping table" button.
Design
You can find more information on this topic in the "COMOS Platform Administration" manual,
keyword "Configuring a mapping table".
Control element
"Insert in template" button
"Attribute" column
"Description" column
"Link type" column
"Source object" column
"Property" column
"Value" column
See also
Configuring the mapping table of the signal designations (Page 159)
Adopting a mapping table as a template (Page 162)
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA
Description
Saves the assignments in the template of the control module type
used
Attribute to which the information is transferred
Description of the set target attribute
To change the link type, double-click in this column and select the
required type from the list.
● "Static"
The linked value is not immediately accepted in the case of a
static link. You initiate the use manually. A static link only serves
as a basis of comparison. The content is not applied.
● "Dynamic"
In the case of a dynamic link, the contents are always transferred
from the source object to the attribute.
● "Full dynamic" (recommended)
All properties of the linked attributes are automatically
transferred in both directions.
Object from which the information is read
The object can be set as follows:
● Via drag&drop from within the Navigator
● In the navigation assistant
See also chapter Reference to the navigation assistant
(Page 204).
Contains the property that is being read out
If necessary, double-click in this column to select another property
from the list.
Contains a preview of the information to be transferred
20.4 Reference to the mapping table
Reference
203