Importing Et 200M From Pcs 7 To Paa; Importing Et 200Pa Smart From Pcs 7 To Paa - Siemens SIMATIC PCS 7 Operating Manual

18.15

Importing ET 200M from PCS 7 to PAA

Requirements
The PCS 7 project with ET 200M is created.
See also section
200 stations using HW configuration tool (Page 124).
The folowing configurations are possible:
● ET 200M with single PROFIBUS interface module
● ET 200M with redundant PROFIBUS interface module
● ET200M with PROFINET interface module
Procedure
1. In the menu bar, select the "Plugins > Automation > PCS 7 interface > Import / Export
PCS 7" command.
2. Select the "Import" tab.
See also chapter Importing the hardware configuration (Page 182).
Result
The hardware is imported to the current PAA project. The physical structure is created including
the bus modules and Profile rail.
18.16

Importing ET 200PA SMART from PCS 7 to PAA

Requirements
The PCS 7 project with ET 200PA SMART is created.
The following configurations are possible:
● ET 200PA SMART with single PROFIBUS interface module
● ET 200PA SMART with redundant PROFIBUS interface module
Procedure
1. In the menu bar, select the "Plugins > Automation > PCS 7 interface > Import / Export
PCS 7" command.
2. Select the "Import" tab.
See also chapter Importing the hardware configuration (Page 182).
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA
18.16 Importing ET 200PA SMART from PCS 7 to PAA
Creating bundles while creating ET 200M station in chapter Configuring ET
Import from PCS 7 to PAA
185