Table of Contents
Advertisement
Iridium Satellite LLC
9601 SBD Transceiver Preliminary Product Developers Guide Appendix A –AT Command Reference
V1.24 120505
2.34 +SBDDET –Short Burst Data: Detach (new)
Exec Command:
+SBDDET
Initiates an SBD session to detach the Transceiver from the Gateway.
Command Response:
+SBDDET:<status>,<error>
where:
:
<status>
Detach successfully performed
0
An error occurred while attempting the detach
1
:
<error>
Gateway-reported values
No error.
0
Reserved, but indicate success if used.
1..4
Reserved, but indicate failure if used.
5..14
Access is denied.
15
Transceiver-reported values
Transceiver has been locked and may not make SBD calls (see
16
command).
Gateway not responding (local session timeout).
17
Connection lost (RF drop).
18
Reserved, but indicate failure if used.
19..31
No network service, unable to initiate call.
32
Antenna fault, unable to initiate call.
33
Radio is disabled, unable to initiate call (see
34
Transceiver is busy, unable to initiate call (typically performing auto-
35
registration).
Reserved, but indicate failure if used.
36..
This instructs the Gateway to disable (detach) SBD automatic notifications for the
calling Transceiver. Successful completion of the detach command implies that the
Gateway has performed the requested detach action and the Transceiver is no longer
registered. This session does not transfer any MO or MT messages.
Note: A user can send an MO-SBD message and request a detach at the same time
by using the
command. The
+SBDI
Iridium Satellite LLC Proprietary & Confidential Information
Information contained herein is subject to change without further notice
command always requests a detach.
+SBDI
command).
*Rn
+CULK
47
Advertisement
Table of Contents
