Table of Contents
Advertisement
Iridium Satellite LLC
9601 SBD Transceiver Preliminary Product Developers Guide Appendix A –AT Command Reference
V1.24 120505
2.11 &V –View Active and Stored Configuration
View the current active configuration and stored profiles.
2.12 &Wn –Store Active Configuration
Store the active profile in non-volatile memory. This is used to store user configurations
for later use.
Store current (active) configuration as profile 0.
0
Store current (active) configuration as profile 1.
1
2.13 &Yn –Designate Default Reset Profile
Select profile for use after power-up.
Select profile 0 (default).
0
Select profile 1.
1
2.14 %R –Display Registers
Display all the S-registers in the system.
2.15 *F –Flush to Eeprom (new)
Flush all pending writes to Eeprom, shut down the radio, and prepare the 9601 to be
powered down. The command returns
remove the power without losing non-volatile data.
Note: This command stops the 9601 from responding to any more commands, but
does not actually power it down. The only way to power down the 9601 is for the FA to
remove the power or to de-assert the on/off control line.
Note: After an SBD session, the new SBD MOMSN is always flushed to Eeprom before
the
result is issued.
+SBDI
Iridium Satellite LLC Proprietary & Confidential Information
Information contained herein is subject to change without further notice
upon completion, at which point it is safe to
OK
34
Advertisement
Table of Contents
