Iridium 9601 Product Developer Manual page 32

Iridium Satellite LLC
9601 SBD Transceiver Preliminary Product Developers Guide Appendix A –AT Command Reference
V1.24 120505
1 Introduction
This document specifies the AT Commands supported by the 9601 Transceiver.
Informative examples are presented in Section 3.
2 AT Commands
The 9601 is configured and operated through the use of AT commands. Only AT
Commands that are relevant to the 9601 are included. AT Commands related to
functionality of the 9522 and 9522A LBTs are not included. Note that Commands may
be modified, removed or added and that you should not rely on this document as a
definitive statement of the functionality of the commercial 9601 Transceiver.
2.1 AT –ATtention Code
This is the prefix for all commands except
respond .
OK
2.2 A/ - Repeat Last Command
Repeat the last command issued to the 9601 unless the power was interrupted or the
unit is reset. is not followed by
A/
2.3 En –Echo
Echo command characters.
Characters are not echoed to the DTE.
0
Characters are echoed to the DTE (default).
1
2.4 In –Identification
Requests the 9601 to display information about itself.
" " ( f o r c o mp a t i b i l i t y o n l y )
0 2400
" " ( f o r compatibility only)
1 0000
" " ( f o r c o mp a t i b i l i t y o n l y )
2 OK
"
3 XXXXXXXX
"
4 IRIDIUM 9601
" " ( f o r c o mp a t i b i l i t y o n l y )
5 8816
" " ( F a c t o r y i d e n t i t y )
6 XXX
"
7 XXXXXXXX
Iridium Satellite LLC Proprietary & Confidential Information
Information contained herein is subject to change without further notice
A/
.
<CR>
" ( S o f t w a r e r e v i s i o n l e v e l )
" ( P r o d u c t d e s c r i p t i o n )
" ( H a r d w a r e s p e c i f i c a t i o n )
. When entered on its own, the 9601 will
32