Install The Booth Control; System - Graco ProMix PD2K Installation Manual

Upgrade Software Software for
Upgrade Upgrade Software

System

System System
If upgrading your ProMix PD system to a PD3K+,
the software will need to be upgraded when starting
up the system. The PD3K+ software comes
on a black token with upgrade kit 26C416 (see
10. Upgrade Kit, page
Install Install the Install the PD3K+ the PD3K+ Upgrade PD3K+ Upgrade Token Upgrade
1. Shut off the PD2K power switch.
2. Remove the token access panel.
Figure 15 Remove Token Access Panel
3. Insert and press token (T) firmly into slot.
NOTE: There is no preferred orientation of the
NOTE: NOTE:
token.
Figure 16 Insert Token
4. Turn the power switch back on. The red indicator
light (L) will flash until the new firmware is
completely loaded.
5. Remove the token (T).
6. Replace the token access panel.
332457M
for ProMix ProMix PD3K+ PD3K+
for ProMix PD3K+
28).
Token Token

Install the Booth Control

Install the the Booth Booth Control
Install Install the Booth
1. Use screws (S) to mount the bracket (10) for the
Booth Control (13) on the wall. Connect a ground
wire (G) to one of the screws. Connect the other
end of the ground wire to a true earth ground.
NOTE: A Dual Panel system has two Booth
NOTE: NOTE:
Control modules, one for each mix unit. They
may be identified by a label on the rear denoting
them as "1" or "2",
Figure 17 Ground the Booth Control Bracket
2. Snap the Booth Control into the bracket.
3. Connect the Booth Control to the Isolation Board
in the Electrical Control Box, using the 50 ft (15.2
m) intrinsically safe CAN cable (163).
NOTE: NOTE: NOTE: For a list of alternate cable lengths, see
Electrical Schematics, page
of cable used in the hazardous location must not
exceed 120 ft (36 m). The total length of all cable
used in the system must not exceed 150 ft (45 m).
Figure 18 Install the Booth Control
Control
Control
.
46. The total length
31