Install The Display Module - Graco ProMix PD2K Installation Manual

Install the Display Module

Install the the Display Display Module
Install Install the Display
1. Use the screws (11) to mount the bracket (10) for
the Advanced Display Module (12) on the front of
the Control Box or on the wall, as you prefer.
2. Snap the Advanced Display Module into the
bracket.
Figure 13 Install Display Module
3. Connect one end of the 5 ft (1.5 m) CAN cable
(provided) to the Advanced Display Module
(M). The other end of the cable comes from the
factory connected to the Enhanced Fluid Control
Module (EFCM).
NOTE: For a list of alternate cable lengths, see
NOTE: NOTE:
Electrical Schematics, page
all cable used in the system must not exceed 150
ft (45 m).
30
Module
Module
46. The total length of
Figure 14 Advanced Display Module Connection
Ports
Item Description
Item Item Description Description
J Battery Cover
K Model Number
L
USB Drive Interface
M CAN Cable Connection
N ADM Status LEDs
P Accessory Cable Connection
R Token Access Cover
332457M