Graco ProMix PD2K Installation Manual page 36

Fluid Supply
For PD3K+ PD3K+ Systems Systems
For For PD3K+ Systems
Solvent connections for a PD3K+ system using
mix-at-belt manifolds will be the same as shown
above for the PD2K system. However, the wiring
of the solvent flow switch needs to be moved from
EFCM connector J6 pins 11-12 to EFCM connector
J6 pins 9-10.
Solvent connections for mix-at-wall manifolds
should follow the procedure as outlined in Solvent
Connections section of the PD2K Automatic Systems
Installation manual (332458).
Use the following table for wire connections of the
solvent flow switches for a PD3K+ system.
36
Solvent Flow Switch 1:
Component A Remote
Solvent
Solvent Flow Switch 2:
Component B Remote
Solvent
Solvent Flow Switch 3:
Component C Remote
Solvent
Solvent Flow Switch
4: Mix-at-Belt
Solvent/Component
D Remote Solvent
EFCM Connector J6
Pins 11-12
EFCM Connector J7
Pins 9-10
EFCM Connector J6
Pins 7-8
EFCM Connector J6
Pins 9-10
332457M